= PDAFomi_get_interp_coeff_lin = This page documents the routine `PDAFomi_get_interp_coeff_lne` of PDAF-OMI. The routine is called in `init_dim_obs_OBSTYPE of an obseration module to initialize interpolation coefficients in 1, 2, or 3 dimensions. It is used if the observation operator performs linear interpolation (usually `PDAFomi_obs_op_interp_lin`). || See the [wiki:OMI_observation_operators page describing PDAF-OMI observation operators] for a general overview.|| The interface is: {{{ SUBROUTINE PDAFomi_get_interp_coeff_lin(num_gp, n_dim, gcoords, ocoord, icoeff) INTEGER, INTENT(in) :: num_gp ! Length of icoeff INTEGER, INTENT(in) :: n_dim ! Number of dimensions in interpolation REAL, INTENT(in) :: gcoords(:,:) ! Coordinates of grid points REAL, INTENT(in) :: ocoord(:) ! Coordinates of observation REAL, INTENT(inout) :: icoeff(:) ! Interpolation coefficients (num_gp) }}} '''Notes:''' * It is required that num_gp=2 for n_dim=1; num_gp=4 for n_dim=2; num_gp=8 for n_dim=3. * In the array `gcoords`, the first index specifies the grid point while the second specifies the coordinate, thus `gcoords(1,1)` is the first coordinate for grid point 1, `gcoords(1,2)` is the second coordiate for grid point 1, while `gcoords(2,1)` is the first coordiate for grid point 2. The coordinates need to be consistent with the indices specified in `thisobs%id_obs_p` since these specify the elements of the state vector that are interpolated. Only the first `n_dim` entries of ocoord will be used for the interpolation. * `ocoord(:,i)` holds the list of the coordinates for the observation with index i (different from the use in `gcoords`) * The order of the coordinates and coefficients is the following: {{{ (7)------(8) /| /| with (5)+-----(6)| - column 1 | | | | / column 2 |(3)-----+(4) | column 3 |/ |/ (1) ---- (2) thus gcoords(1,1)/=gcoords(2,1), but gcoords(1,1)=gcoords(3,1)=gcoords(5,1), gcoords(1,2)/=gcoords(3,2), gcoords(1,2)=gcoords(2,2)=gcoords(5,2), gcoords(1,3)/=gcoords(5,3) gcoords(1,3)=gcoords(2,3)=gcoords(3,3) }}} * For 1D linear interpolation (n_dim=1) only the coordinates for grid points 1 and 2 are used to compute the coefficients * For bi-linear interpolation (n_dim=2) only the coordinates for grid points 1, 2, and 3 are used to compute the coefficients * For tri-linear interpolation (n_dim=3) only the coordinates for grid points 1, 2, 3, and 5 are used to compute the coefficients